Dxf-801/801Ce Viewfinder - Sony DXC-D35H/D35PH Operating Instructions Manual

DXF-801/801CE Viewfinder

You can switch the scan size of the DXF-801/801CE
in accordance with the aspect ratio selected on the
camera or camcorder.
1 Eyepiece focusing knob
2 Stopper
Microphone holding screw
Microphone holder
Microphone
3 LIGHT switch and light
HIGH LOW OFF
LIGHT
1 Eyepiece focusing knob
Turn this to adjust the viewfinder focus to match your
eyesight. (See page 88.)
2 Stopper
Lift up when detaching the viewfinder (See page 32).
3 LIGHT switch and light
The light lights the lens and the switch controls the
light as follows.
HIGH/LOW: Turn the light on and control the
brightness.
OFF: Turns the lights off.
4 TAKE/TALLY indicator
TALLY
TAKE REC BATT
5 BATT indicator
6 REC/TALLY indicators
7 GAIN UP indicator
SHUTTER GAIN UP
8 SHUTTER indicator
Eye cup
9 PEAKING control
0 CONTRAST control
qa Tally lamp
qs BRIGHT control
qd Eyepiece release catch
qf TALLY switch
qg DISPLAY switch
qh Viewfinder connector
4 TAKE/TALLY indicator (orange)
When using the ClipLink function while shooting, this
indicator lights when the TAKE button (7 on page
17) has been pressed to set a Mark IN point and goes
out when a Mark OUT point is set.
5 BATT (battery) indicator (red)
This lights when the battery capacity is low.
Note
When using a camera control unit, this indicator
flashes when
you operate the controls, but this is not a malfunction.
21
Chapter 1 Overview