Parallel Port Devices; Serial Port Devices; Usb Devices - Fujitsu Lifebook E360 Manual

C A U T I O N
Installing or removing a card while your
notebook is in the process of going
through the power on or power off
sequence may damage the card and/or
your notebook.
4. When the PC Card is fully inserted, the eject
button will pop out.
5. Flip this button toward the front of your
notebook to fold it out of the way.
6. When the card is installed, lock it in place
by sliding the Lock button toward the front
of your notebook. (Figure 4-10.)
C A U T I O N
Windows has a shutdown procedure for
PC Cards that must be followed before
beginning to remove a card.
U s e r I n s t a l l a b l e
Removing PC Cards
1. Shutdown operation of the card.
2. Click on the PC Card indicator on the
Windows taskbar.
3. From the PC cards properties window; select
the card to be removed and click on the
Stop button.
4. Verify that the You can safely
remove your card message appears.
5. If the device cannot be removed
message appears, save all files, close all
applications, exit Windows and then shutoff
the power with the power switch.
(See Power Off on pages 21-22.)
6. Slide the lock toward the rear of your
notebook to release the card.
7. Flip the eject button toward the rear of your
notebook until it is fully extended.
8. Press the eject button in until it is flush with
the side of your notebook.
9. Grasp the card and pull it clear of
your notebook. (See Figure 4-10.)
L i f e B o o k E S e r i e s f r o m F u j i t s u
F e a t u r e s
C A U T I O N
If the PC Card has an external connector
and cable, do not pull on this cable when
removing the card.

PARALLEL PORT DEVICES

To connect a parallel interface device to the par-
allel port, be sure that the connector is the right
size and aligned, then push in until it is fully
seated. When it is seated tighten the hold-down
screws, one on each end of the connector.
(See Figure 1-10 on page 10.)

SERIAL PORT DEVICES

To connect a Serial (RS-232C) device to the ser-
ial port, be sure that the connector is the right
size and aligned, then push in until it is fully
seated. When it is seated tighten the hold-down
screws, one on each end of the connector.
(See Figure 1-10 on page 10.)

USB DEVICES

When installing a device on the USB Port, be
sure that the connector is the right size, aligned,
and fully seated. (See Figure 1-9 on page 9.)
77