Section Two; Starting Your Lifebook E Series From Fujitsu; Power Sources - Fujitsu Lifebook E360 Manual

S e c t i o n T w o

SECTION TWO

STARTING YOUR LIFEBOOK
E SERIES FROM FUJITSU
This section describes the processes of starting
your LifeBook for the first time, initial software
setup and registration.

POWER SOURCES

Your notebook has four possible power sources:
the primary Lithium ion battery; an optional
dual Lithium ion battery configuration; the AC
adapter; or an optional auto/airline adapter.
Connecting the Power Adapters
The AC adapter or an optional auto/airline
adapter provides power for operating your
notebook and charging the batteries.
To Connect the AC Adapter
1. Connect the two pieces as shown. (Figure 2-1.)
2. Plug the DC Output cable of the AC adapter
into the DC Power jack on the right-side
panel of your notebook.
3. Plug the AC adapter into an AC
electrical outlet.
14
Figure 2-1 Connecting the AC Adapter
To Connect the Optional Auto/airline Adapter
1. Plug the DC Output cable into the DC
Power jack on the right-side panel of
your notebook.
2. Plug the auto/airline adapter plug into the
cigarette lighter of a car or other vehicle with
the ignition key in the On or the Accessories
position or into the DC Power jack on an
airplane seat.
To Switch From AC Adapter Power or
Auto/Airline Adapter To Battery Power
1. Be sure that you have at least one charged
battery installed.
2. Remove the AC or auto/airline adapter.
C A U T I O N
The primary Lithium ion battery is not
charged when you purchase your note-
book. Initially you will need to connect the
AC adapter or the auto/airline adapter to
use it. If you purchase a second Lithium
ion battery it will not be charged when
you get it. You will need to charge it
prior to use.