Your Save-To-Disk File Allocation - Fujitsu Lifebook E360 Manual

You will only have to change the utility settings
if you want to:
Change the date or time. (You can also
do this without entering the setup utility,
through your operating system. (See your
operating system manual.)
Change the primary boot device.
Change the power saving parameter settings.
(For a more convenient process, see the Windows
Power Management Control Panels.)
Change a port address or other parameter.
Change an audio parameter setting.
Change the selection of whether to use the
built-in display, an external monitor or both.
(For a more convenient process, see the Fn key
on page 33.)
Change the system data security settings.
U s i n g Y o u r L i f e B o o k E S e r i e s
Entering the Setup Utility
You can enter the setup utility whenever you
turn on or reset the system. To do this:
1. Allow the system to start booting.
2. As soon as the Fujitsu logo appears on the
screen, press the F2 key.
3. The Main menu of the setup utility then
appears with the current settings of the
parameters displayed.
4. If you wish to go to one of the other setup
menus, press the or the key to find the
menu you require.
BIOS Guide
A guide to your units BIOS is available on-line.
Go to our service and support web site at
www.8fujitsu.com, click on Self Help Center,
select E Series from the pull-down menu, then
L i f e B o o k E S e r i e s f r o m F u j i t s u
select BIOS Guides from the pull-down menu on
the E Series page. This will take you to the BIOS
guide page, where you can select your units BIOS
from the pull-down menu. To find your units
BIOS number, check your packing slip.
P O I N T
If your data security settings require it,
you may be asked for a password before
the Main menu will appear.
YOUR SAVE-TO-DISK
FILE ALLOCATION
Your notebook comes with an allocation of space
on the internal hard drive adequate to operate the
Save-to-Disk function for the amount of memory
installed at the factory. If you add a memory
upgrade module or do not use the Save-to-Disk
function and wish to free up the disk space, you
will need to change your allocation. The utility to
change the allocations is PHDISK.EXE and is
activated from the MS-DOS prompt.
63