Memory Upgrade Module - Fujitsu 565Tx User Manual

S e c t i o n F o u r
5. Slide the release latch on the side of the
external floppy disk drive adapter toward the
bottom of the adapter. Note Finger ridges are
on the bottom.
6. Slide the floppy disk drive out of the adapter.
C A U T I O N
The external floppy disk drive adapter i s
designed only for use with a floppy disk
d r i v e. Do not connect any other device
or you could damage the device or
your notebook.
P O I N T
Disconnecting and storing the Media-
Connect when it is not in use protects it
and your notebooks MediaConnect port
from potential damage from accidental
tugging on the cable and connector.
106
Figure 4-8 Opening the Memory Upgrade Compartment
Figure 4-9 Installing a Memory Upgrade Module

MEMORY UPGRADE MODULE

Installing a Memory Upgrade Module
Your notebook comes with 32MB of installed
SDRAM. To increase your memory capacity
you may install a memory upgrade module
in the memory upgrade compartment in
the bottom of your notebook. The memory
upgrade module is a dual-in-line memory
module (DIMM). You may add modules of
different capacity. SDRAM modules are
recommended but EDO RAM modules will
work. Installing an EDO RAM module will
cause your entire system to operate at the
much slower EDO timing.
C A U T I O N
Never remove screws except the ones
s p e c i fically shown in the directions for
installing and removing the memory
upgrade module.