Memory Upgrade Module; Installing A Memory Upgrade Module - Fujitsu P2110 Manual

Hide thumbs Also See for P2110:

Table of Contents

SECTION 2

9. Memory Upgrade Module

Your Fujitsu LifeBook notebook comes with 128MB of on-board high speed Synchronous Dynamic

RAM (SDRAM) factory installed. To increase your LifeBook notebook's memory capacity, you may

install an additional memory upgrade module. The memory upgrade must be Micro dual-in-line (uDIMM)

SDRAM module. To ensure 100% compatibility, purchase the SDRAM module only from Fujitsu.

CAUTION

The memory upgrade module can be severely damaged by electrostatic discharge (ESD). Be

sure you are properly grounded when handling and installing the module.

To install a memory upgrade module follow these steps:

WARNING

You must turn off power and remove any modem connection before installing the memory

upgrade module.

1 Turn off power to your LifeBook notebook, and remove any power adapter, battery pack, and

modem connection.

2 Place your LifeBook notebook with the bottom facing up on a clean work surface.

3 Using a Phillips screwdriver, remove the screw from the hole indicated.

4 Turn the system over and open the top cover all the way, so that it is lying flat on the work

surface.

Table of Contents