Table of Contents
Advertisement
Remove the clasp coupling of lamp attachment on the reverse side and the lamp unit
4
Lamp attachment replacement procedures
Insert the "a" section of the lamp attachment into the "A" section of the lamp unit.
1
Hang the lamp attachment into the clasp-shaped part of the lamp unit
Stamp of "0°" or "90°"
"a"
Figure 1-1
.
"a"
.
44
.
Lamp attachment
"X" or "+"
Hole
"a"
Figure 3
Figure 5
"b"
"X" or "+"
Hole
Figure 1-2
In case the lamp attachment is bent in any
direction other than stated in the written
instructions, or if it is modified, or remodeled, the
lamp attachment will be damaged or break off.
This may lead to failure of the main unit of the
projector. Moreover, in case it is repeatedly
installed and removed, it may be possible that the
"a" section of the clasp section breaks off. In this
case, please purchase and use a new
replacement lamp attachment. As the folding
section of the "b" section is fragile, please be
careful when bending it in the direction of the
arrow.
Lamp unit
"A"
Figure 2
CAUTION
Advertisement
Table of Contents
