Check Safety Interlock System; Clean Debris Off Mower; Fuel System; Storage Procedure - Snapper 7800946-02 Operator's Manual

Check Safety Interlock System

1. Start the mower.
2. Release the blade control. The engine must stop
within 3 seconds.
If the engine does not stop within 3 seconds, do not
use the mower. Bring the mower to an authorized
dealer for service.

Clean Debris Off Mower

WARNING
!
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP engine
and blade. Disconnect spark plug wire and secure
away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for all
components to cool. Wear heavy leather gloves when
handling or working around cutting blades. Blades are
extremely sharp and can cause severe injury.
1. Clean dirt and debris from the top of the mower
deck.
2. Clean any debris buildup on or around the engine,
etc.
While cleaning, check components for wear or dam-
age. Replace worn or damaged components immedi-
ately.

Storage Procedure

WARNING
!
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP engine
and blade. Disconnect spark plug wire and secure
away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for all
components to cool. Wear heavy leather gloves when
handling or working around cutting blades. Blades are
extremely sharp and can cause severe injury.
Prepare the mower for "end of season" storage as fol-
lows:
1. Disconnect the spark plug wire and secure away
from the spark plug.
2. Drain the fuel tank and let the engine run until all
fuel is out of the carburetor.
NOTE: If using a fuel stabilizer, there is no need to
drain the fuel tank. Refer to the section entitled 'Fuel
System'.
3. Use a brush or compressed air to remove loose
debris, then use a damp cloth to wipe down the
unit.
4. Tilt the mower up on its rear wheels and inspect
the underside of the deck. (Do not tilt the mower
with the spark plug or carburetor down.) Scrape
away stubborn accumulation of grass with a putty
knife and/or wire brush.
5. Lubricate all exposed metal with a light coating of
oil to prevent corrosion.
6. Carefully fold the handles, flexing the control
cables to prevent cable damage.
!
7. Store the mower in a shed or other dry area, pro-
tected from weather.

Fuel System

Fuel can become stale when stored over 30 days.
Stale fuel causes acid and gum deposits to form in
the fuel system or on essential carburetor parts. To
keep fuel fresh, use Briggs & Stratton ® Advanced
Formula Fuel Treatment & Stabilizer, available
wherever Briggs & Stratton genuine service parts are
sold.
For engines equipped with a FRESH START ® fuel
cap, use Briggs & Stratton FRESH START ® avail-
able in a drip concentrate cartridge.
There is no need to drain gasoline from the engine
if a fuel stabilizer is added according to instructions.
Run the engine for 2 minutes to circulate the stabilizer
throughout the fuel system before storage.
If gasoline in the engine has not been treated with a
fuel stabilizer, it must be drained into an approved con-
!
tainer. Run the engine until it stops from lack of fuel.
The use of a fuel stabilizer in the storage container is
recommended to maintain freshness.
Maintenance
19
en