Asus A7V400-MX/S User Manual page 53

PCI/VGA Snoop Palette [Disabled]
Some non-standard VGA cards, like graphics accelerators or MPEG video cards,
may not show colors properly. Setting this field to [Enabled] corrects this problem.
If you are using a standard VGA card, leave this field to the default setting
[Disabled]. Configuration options:
Assign IRQ for VGA [Enabled]
Setting this option to [Enabled] allows the BIOS to automatically assign an IRQ
address for the VGA controller. Configuration options: [Disabled] [Enabled]
Assign IRQ for USB [Disabled]
Setting this option to [Enabled] allows the BIOS to automatically assign an IRQ
address for the USB controller. Configuration options: [Disabled] [Enabled]
IRQ Resources
IRQ 3 assigned to
IRQ 4 assigned to
IRQ 5 assigned to
IRQ 7 assigned to
IRQ 9 assigned to
IRQ 10 assigned to
IRQ 11 assigned to
IRQ 12 assigned to
IRQ 14 assigned to
IRQ 15 assigned to
F1 : Help ↑↓ ↑↓ ↑↓
↑↓ ↑↓
ESC : Exit →← →← →←
→← →←
IRQ 3, 4, 5, 7, 9, 10, 11, 12, 14, 15 assigned to [PCI Device]
The IRQ Resources sub-menu is activated when the Resources Controlled by
parameter is set to [Manual]. Select [PCI Device] to assign an IRQ address to a
Plug and Play device. Setting to [Reserved] reserves the IRQ address.
Configuration options: [PCI Devices] [Reserved]
ASUS A7V400-MX motherboard user guide
IRQ Resources
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
: Select Item -/+
: Select Menu Enter : Select Sub-menu
Select Menu
Item Specific Help
Where resources are
controlled manually,
assign each system
interrupt a type,
depending on the type
of device using the
interrupt.
: Change Value F5 : Setup Defaults
F10 : Save and Exit
2-21