Operating Your Snowplow; Joystick Control - Blizzard POWER PLOW 8100PP Owner's Manual

Snowplow

Hide thumbs

Table Of Contents

Table of Contents

POWER PLOW™ BLADE

JOYSTICK SOLENOID CONTROL

WARNING

To prevent accidental movement of the blade,

always move the ON/OFF switch to OFF

whenever the snowplow is not in use. The

power indicator light will turn OFF.

CAUTION

DO NOT hold control lever in RAISE, ANGLE

LEFT, or ANGLE RIGHT position after blade

has reached desired position. To do so will

use excess current and overheat components.

1. Turn the vehicle ignition switch to the "ON" or

"ACCESSORY" position.

2. Move control ON/OFF switch to the "ON" position.

The power indicator light glows red, indicating

the control is ON. The power indicator light glows

red whenever the control and the vehicle ignition

switch are both ON, the electrical connections to

the snowplow are completed and the power switch

on the light tower is in the "PLOWING" position.

If the power switch is in the "OFF" position, the

power indicator light will ﬂ ash.

The ON/OFF switch operates as an emergency

stop, if required.

Function Time-Outs

All control functions, except LOWER/FLOAT, time out

(stop) automatically after a period of time. This is to

limit the amount of electrical energy required from the

vehicle.

NOTE: If control function times out before desired

blade movement is complete, release the lever

to the center position, then move back into the

desired function.

Lit. No. 40691, Rev. 05