Mounting Snowplow To Vehicle - Blizzard POWER PLOW 8100PP Owner's Manual

MOUNTING SNOWPLOW (ON)
WARNING
Keep 8' clear of the blade when blade is being
raised, lowered, or angled. Do not stand
between the vehicle and blade or directly in
front of blade. If the blade hits or drops on
you, you could be seriously injured.
WARNING
Inspect snowplow components and fasteners
for wear or damage whenever mounting or
removing the snowplow. Worn or damaged
components could allow the snowplow to
drop unexpectedly.
NOTE: Use dielectric grease to prevent corrosion
on all connections.
1. Slowly drive vehicle forward to engage mount
adapter into A-frame.
2. Move power switch to center, or "OFF," position.
3. Plug in electrical harnesses.
4. Push and hold power switch RIGHT and push UP
and hold Arm/Blade Operation switch. Arm will
engage mount adapter and pull snowplow toward
vehicle.
Arm / Blade
Power
Operation
Switch
Switch
Switch
Label
Lit. No. 40691, Rev. 05

MOUNTING SNOWPLOW TO VEHICLE

Light
Tower
5. Rotate and release the hitch pin. The hitch pin is
fully engaged when the pin handle is against the
pin guide plate.
Hitch
Pin
6. Repeat Step 5 on the passenger's side.
7. While holding power switch RIGHT, push DOWN
and hold Arm/Blade Operation switch. Arm will
disengage mount adapter to relieve tension on
the stand.
Light Tower
Blade
Power Switch
Upper Hole
Stand
Stand Handle
8. Pull the stand handle up. The stand will lift off the
ground. Pull the stand pin out. Rotate the stand up
until the stand pin seats into the upper hole on the
A-frame. The pin must lock into the upper A-frame
hole.
9. Repeat Step 8 on the passenger's side.
10. Move the power switch to the left or "PLOWING"
position.
16
Mount
Adapter
Pin
Guide Plate
Pin
Handle
Arm/Blade
Boot
Operation Switch
Hitch Pin
A-Frame
Raise
OFF
Lower
POWER OPERATION ARM/BLADE
48207
Arm
Stand Pin
Shoe
May 1, 2021
Mount
Adapter
ON