Stiga EL 340 Li 48 Operator's Manual page 54

Battery is not inserted or is
inserted incorrectly
Low battery
Thermal switch has tripped
Motor start-up is slow
2. The motor shuts down whilst working
Battery is not inserted
correctly
Low battery
Thermal switch has tripped
Obstructions that prevent
rotation of the cutting
means
3. The motor is running but
the cutting means is stationary
The cutting means fittings
are loose
4. Excessive noise and/or vibration
is experienced whilst working
Cutting means fittings are
loose or the cutting means
is damaged
5. Battery power reserve is low
Severe working conditions
requiring greater current
absorption
Battery is insufficient for
operating requirements
6. The battery charger does not recharge
the battery (red light steady or flashing)
Battery is not correctly
inserted in the battery
charger
Open the hatch and check
that the battery is fitted in
its housing correctly
(see 4.3c)
Check the battery status
and recharge if necessary
(see 4.3)
Allow the machine to cool
down
Press and hold the switch
for 1-3 seconds (see 2.2)
Open the hatch and check
that the battery is fitted
in its housing correctly
(see 4.3c)
Check the battery status
and recharge if necessary
(see 4.3)
Wait for at least 5 minutes
and then restart
the machine.
Remove the safety key.
Always make sure the air
intakes are free of debris.
Remove the safety key,
put on your work gloves
and remove any grass
remains or debris from the
lower part of the machine
and/or the discharge
channel
Switch the motor off
immediately
and contact the nearest
Authorised Service Centre
(see 4.1)
Switch the motor off
immediately
and contact the nearest
Authorised Service Centre
(see 4.1)
Optimise operations
(see 3)
Use a second battery
or an extended battery
(see 5.2)
Check to make sure it is
inserted correctly
(see 4.3b)
Unsuitable environmental
conditions
Dirty contacts
7. The battery charger does not recharge
the battery (no LED is on)
The battery charger is not
energised
Faulty battery charger
For all other situations not included in the list, please con-
tract your Dealer or an Authorised Service Centre.
EN - 8
Recharge the battery
in places with suitable
temperatures (see 4.3)
Clean the contacts
Check it is plugged in
and the power socket is
energised
Replace with an original
spare part