Omron NXEIP202 User Manual page 361

Parameter name
Reserved
General Status
Size of Additional Status
Total power on time
Format for Error Response
Parameter name
Reply Service
Reserved
General Status
Size of Additional Status
Additional status
*1. If the general status code in the response code is 0x1F (Vendor specific error), the value is 0x01.
*2. This is stored only when the value of Size of Additional Status is 0x01.
CIP error code
General status code (hex)
02
13
15
1F
20
*1. Refer to General Status Code on page A-30 for error descriptions.
 Change NX State (Service Code: 39 Hex)
The request format, format for normal responses, format for error responses, and CIP error codes
for the Change NX state object are given below.
Request Format
Parameter name
Service
Request Path Size
Request Path
Unit No
State
Reserved
Output data access
watch dog timeout
time (ms)
*1. If the communications master does not write the output data within the access monitor timeout time, the
outputs from the NX Unit are stopped.
NX-series EtherNet/IP Coupler Unit User's Manual (W536)
Description
Reserved
Code that indicates normal
Size of Additional status
Total power-ON time
Description
Reply to Switch parameter write mode
service
Reserved
Current error code defined by CIP
Size of Additional status
Additional status
Description
Service code
Request path size
Request path
Unit number
State of NX Unit
Reserved
Monitoring timeout time for
*1
output data access
Data
type
USINT
USINT
USINT
ULINT
Data
type
USINT
USINT
USINT
USINT
UINT
*1
Error code
Resource unavailable
Not enough data
Too much data
Vendor specific error
Invalid parameter
Data type
USINT 39
USINT 02
Padded EPATH 20742401
UINT 0000: Communications Coupler
Unit
0001 or higher: Not supported.
BYTE 04: Safe-Operational
08: Operational
USINT 00
UDINT 0000000A to 0036EE80: Time-
out time
Appendices
Value (hex)
00
00
00
Total
power-ON time
Value (hex)
B8
00
Current error code
*1
00
*2
Additional status
Value (hex)
*2
A - 13
A