Olivetti PGL2535 Operation Manual page 42

Installing and Setting up the Machine > Network Setup
Preparation before configuring the Wireless Network by Using Computer
Before configuring the wireless network by using computer, connect the machine with the following methods.
Wired Connection directly by Using LAN Cable
1
2
3
4
Wireless LAN Connection by Using Wi-Fi Direct
1
2
3
4
5
Connect the machine with a computer via LAN cable when the
machine is powered on.
Turn on the computer.
The Auto-IP (Link-local) address will be assigned to the machine and the computer. This
machine applies Auto-IP as the default settings.
Prints the status page.
Press the [Go] key for 3 to 9 seconds.
Note the IP address.
Enable Wi-Fi Direct mode.
Simultaneously press the [Go] key and [Wi-Fi Direct] key on the operation panel for 3
seconds.
NOTE
You can also enable Wi-Fi Direct from Embedded Web Server RX.
Embedded Web Server RX User Guide
Turn the machine OFF and then ON.
Power On/Off (page 2-9)
Connect a computer or a handheld device with the machine.
Setting Wi-Fi Direct (page 2-20)
Prints the network status page.
Press the [Go] key for 10 seconds or more.
Note the network name (SSID), IP address, and password.
This is printed in Wi-Fi Direct on the Network Status Page.
NOTE
You can also check the network name (SSID), IP address, and password from
Embedded Web Server RX.
Embedded Web Server RX User Guide
2-16