Olivetti PGL2535 Operation Manual page 116

Troubleshooting > Troubleshooting
Symptom
Printouts are curled.
I can't install the
Printing System Driver.
Cannot print.
While "Auto-IP" is set to
[On], the IP address is not
assigned automatically.
The machine is emitting
steam in the area around the
paper ejection slot.
Checkpoints
—
Is the paper damp?
Are you trying to install the driver using
a host name with Wi-Fi or Wi-Fi Direct
enabled?
Is the machine plugged in?
Is the machine powered on?
Are the USB cable and network cable
connected?
Is a value other than "0.0.0.0" entered
for the IP address of TCP/IP(v4)?
Check the room temperature to see if it
is low, or if damp paper was used.
Corrective Actions
Turn the paper over in the cassette, or
turn the orientation 180 degrees around
in which the paper is positioned.
Replace the paper with new paper.
Specify an IP address instead of a host
name.
Plug the power cord into an AC outlet.
Turn on the power switch.
Connect the correct USB cable and
network cable securely.
Enter "0.0.0.0" for the IP address of
TCP/IP(v4).
Depending on the printing environment
and the paper's condition, the heat
generated during printing will cause the
moisture in the paper to evaporate, and
the steam emitted may look like smoke.
This is not a problem, and you can
continue printing. If the steam concerns
you, raise the room temperature, or
replace the paper with a newer, dryer
paper.
6-12
Reference
Page
page 3-2
page 3-4
—
—
page 2-9
page 2-7
page 2-13
—