Cisco NCS 5700 Series Hardware Installation Manual page 75

Connect Router to the Network
Note When the router is fully operational, all ports are populated with cables. It becomes difficult to access the
RJ-45 cable using bare hands. Hence the below procedure is recommended to remove RJ-45 cable from the
management port.
1. Insert the Philips flat-head screwdriver in between the timing ports.
Figure 52: Inserting a screwdriver between the timing ports
2. Press the clip on the RJ-45 jack downwards and pull the RJ-45 jack from the port. This releases the RJ-45
cable from the port.
Hardware Installation Guide for Cisco NCS 5700 Series Fixed-Port Routers
Accessing RJ-45 Cable
69