Cisco NCS 5700 Series Hardware Installation Manual page 53

Install the Chassis
1
3
(NC55-2RU-ACC-SL2) Adjust the slider (push and pull) to place and fix the slider behind the front post. Attach
the slider to the front post with 2 counter sink screws (10-32) and washers. See
(NC55-2RU-ACC-SL2) of the Outer Slider
Note Remove the screw thread adapter present at the front end of the outer slider member if you are unable to
pass the slider through the rack holes. Tighten the screws later after passing the slider through the rack
holes.
Figure 34: Rear and Front End (NC55-2RU-ACC-SL2) of the Outer Slider Member
1
Rack Mount the NCS-57C3-MOD Chassis in a 4-Post Rack using Sliders
Rear End- Outer slider
member
Outer slider member
Member.
Screw thread adapter at the
Front End- Outer slider
member
Hardware Installation Guide for Cisco NCS 5700 Series Fixed-Port Routers
2
Figure 34: Rear and Front End
2
Screw thread adapter at the
Front End- Outer slider
member
Counter sink screws
47