Mpa Leds - Cisco NCS 5700 Series Hardware Installation Manual

MPA LEDs

By default, the display shows all ports and their status. You can change the display mode to show only ports
that are in yellow (YL) state by pressing the DISPLAY button for less than 4 seconds and release. To return
to the default behavior, press and hold the DISPLAY button for more than 5 seconds and release.
Table 17: NCS-57C3 Port Status LED Display
LED Display
GN
YL

MPA LEDs

The STATUS LED is located on the front left of the MPA and the attention (ATTN) is located on the front
right of the MPA. The Link LED for each port is located either between the two rows of ports (each of these
LEDs is a triangle pointing to the port above or below the LED) or under the port.
LED
ATTN
STATUS
Hardware Installation Guide for Cisco NCS 5700 Series Fixed-Port Routers
106
Color Status
Flashing blue The operator has activated this LED to identify this MPA in the
chassis.
Off This LED is not being used.
Green This MPA is operational.
Amber Either of the following conditions:
• The MPA has detected a slot ID parity error and will not power
• The MPA is not fully inserted.
Flashing amber The MPA is booting up or shutting down.
Off The MPA is powered-off and can now be safely removed.
Description
Port is administratively enabled, link is up.
Port is administratively shut down; or port is
administratively enabled, link is down.
on or boot up.
LEDs