Route Processor Card Leds - Cisco NCS 5700 Series Hardware Installation Manual

LEDs
LED
ALRM
(ALARM)
SYNC
FAN
POWER
GNSS

Route Processor Card LEDs

On the NC57-MOD-RP2-E route processor card, the Status (STS), Active (ACT), and Attention (ATTN)
LEDs are located on the lower left front of the route processor card. The management port link and active
LEDs are located immediately below the port on the front of the module.
Color Status
Red Critical alarm - system-scope (including RP0).
Amber Major alarm - system-scope (including RP0).
Off No alarm.
Green SyncE PLL is locked to an input source.
Amber SyncE PLL not-locked to any input source.
Off SyncE not configured.
Fans are working normally.
Green
Amber System is operating with one fan failure.
Red Missing a fan or multiple fan failures.
Chassis not receiving power.
Off
Green Chassis powered on and normal.
Amber Chassis powered off and in retry mode due to thermal or fan failure.
Red Chassis power failure.
Power supply failure, due to one of the following conditions:
• Over voltage
• Over current
• Over Temperature
• Fan failure
Off GNSS is not configured.
Green GNSS is locked to an RF input (Satellites).
Amber GNSS Receiver not-locked RF input (Satellites).
Hardware Installation Guide for Cisco NCS 5700 Series Fixed-Port Routers

Route Processor Card LEDs

103