Before Beginning Operation - Graco BDS Instructions-Parts List Manual

Connect the Industrial PC Interface Cable
The Industrial PC interface cable is terminated on the
controller (inside the cabinet) with an eight pin ethernet
cable. Any connections to the controller cabinet must
be made through approved fittings and connectors
only. Connections must only be installed by a qualified
electrician. Maximum cable length is 50 feet (15.2 m).
Printer Cable (optional)
The optional printer cable is terminated inside the
controller cabinet with a 25 pin "D" connector on the
parallel port of the controller. This port is not used if the
printer option is not purchased. Communication is
standard parallel. Any connections to the controller
cabinet must be made through approved fittings and
connectors only. Connections must only be installed by
a qualified electrician. Maximum cable length for
parallel communication is 25 feet (7.6 m).
Installation

Before Beginning Operation

D Check all fluid and air connections for correctness
and tightness.
D Follow the Initial Startup Sequence on page 17.
D Shipping will affect scale calibration. Be sure to
calibrate the scale after setting up the software.
309279 15