Chapter 3 Setting
3.1
Switch Setting
The switches that determine the operation mode and node address are on the
front panel of the FL911 module.
The method to set the switches is shown below.
3.1.1
TC-net I/O bus address switch (I/O)
The TC-net I/O bus address switches are hexadecimal rotary switches that
determine the address on the TC-net I/O bus.
3.1.2
Node address setting switch (STN-H, STN-L)
The node address setting switches are hexadecimal rotary switches that
determine the node address on the FL-net network.
For setting of the node address, refer to "3.2 Network parameter setting." Set the
station address (1 to 254) that has been assigned upon system configuration in a
HEX code. Assign an address with a different value to each of the nodes in the
system.
Table 3-1 shows the setting of a station address.
Set the station address in hexadecimal.
For example, if the address value is 28, it is '1C' (h) when converted to
hexadecimal. Therefore, set as follows:
For decimal-hexadecimal conversion, refer to "Appendix D
Decimal-hexadecimal conversion table."
16
6F8C1375
Important
Set the switches that determine the operation mode and station address of the FL911 module
before turning the power on.
Table 3-1 Station address setting
Name
STN-H
STN-L
(Note) (h) indicates hexadecimal.
Remark
For setting, use a small slotted screwdriver.
STN-H side: '1'
STN-L side: 'C'
Note
Be careful so that the address does not overlap with other nodes.
Description
Setting range : 01 to FE(h)
STN-H(upper digit address): 0 to F(h)
STN-L(lower digit address): 0 to F(h)