Resetting The Air Filter Service Indicator; Servicing The Engine Oil - Toro Reelmaster 5610-D Owner's Manual

Figure 114

Resetting the Air Filter Service Indicator

1. If a red band displays in the service indicator, press
the reset button at the end of the indicator
115).
g034923
2. Close and latch the hood; refer to
(page

Servicing the Engine Oil

Oil Specification
Use high-quality, low-ash engine oil that meets or exceeds
the following specifications:
•
API service category CJ-4 or higher
•
ACEA service category E6
•
JASO service category DH-2
Important:
higher, ACEA E6, or JASO DH-2 may cause the diesel
particulate filter to plug or cause engine damage.
Use the following engine oil viscosity grade:
•
Preferred oil: SAE 15W-40 (above -18°C (0°F))
•
Alternate oil: SAE 10W-30 or 5W-30 (all temperatures)
Toro Premium Engine Oil is available from your authorized
Toro distributor in either 15W-40 or 10W-30 viscosity
grades.
Checking the Level of the Engine Oil
Service Interval: Before each use or daily
Important:
engine-oil level is above the Full mark on the dipstick,
the engine oil may be diluted with fuel;
If the engine oil level is above the Full mark, change
the engine oil.
The best time to check the engine oil is when the engine is
cool before it has been started for the day. If it has already
been run, allow the oil to drain back down to the sump for
at least 10 minutes before checking. If the oil level is at or
below the Add mark on the dipstick, add oil to bring the oil
g031351
level to the Full mark. Do not overfill the engine with oil.
Important:
upper and lower limits on the oil gauge; the engine may
fail if you run it with too much or too little oil.
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
(Figure
2. Open the hood; refer to
3. Check the level of the engine oil
57
Figure 115
52).
Using engine oil other than API CJ-4 or
Check the engine oil daily. If the
Keep the engine oil level between the
Opening the Hood (page
g378075
Closing the Hood
52).
52).
(Figure 116).