Table of Contents
Advertisement
4. Re-engage parking brakes.
5. Activate anti-tipper (if installed).
Rear side tie-down positions for snap hooks:
1551536-C
1. Attach the snap hooks to the rear frame right above the
adapter plate as shown in the two figures above (see
location of the attachment labels).
2. Attach rear straps to the rail system referring to best
practice recommended instructions from the safety belt
manufacturer.
3. Tighten the straps.
IMPORTANT!
– Make sure that the snap hooks are covered
with slip resistant material to avoid laterally
slipping on the axle.
IMPORTANT!
– Check the plungers are fully engaged on both
sides and located in the same position of the
cut-out section of the rail.
– Make sure that the angle between the rails and
the straps lies between 40° and 45°.
Fit posture belt
WARNING!
The posture belt could be used in addition to but
never as a substitute for an approved passenger
restraint system (3-point belt).
1. Adjust posture belt to fit the wheelchair occupant, see
section 4.1 Posture Belt, page 19.
Transport
39
Advertisement
Table of Contents
