Turning off the tally lamp
The tally lamp lets you know that the
camcorder is recording, receiving
signals from the wireless controller or
counting down for the self-timer.
However, its flashing may be reflected
into the lens during close-up recording,
or when recording through glass.
You may therefore decide to turn it off.
,
+
TAPE
CAMERA
SYSTEM
(
37)
To turn the tally lamp off, open the menu and select SYSTEM. Then
select TALLY LAMP, set it to OFF and close the menu.
• The tally lamp no longer flashes during recording, but it will still light up when
the camcorder receives a signal from the wireless controller and during the self-
timer countdown.
Confirmation/Warning beeps
The camcorder's short operation confirmation beeps are indicated by ` in the
illustrations. Beeps sound upon certain camcorder operations such as when you
turn the camcorder on, during the self-timer countdown, right before the
camcorder's automatic shut-off, and also upon any unusual condition of the
camcorder. Beeps are not recorded on the tape.
,
+
TAPE
CAMERA
SYSTEM
(
37)
To turn the beep off, open the menu and select SYSTEM. Then select
BEEP, set it to OFF and close the menu.
PLAY
,
+
TAPE
(VCR)
TALLY LAMP••ON
,
PLAY
+
TAPE
(VCR)
BEEP••••••••ON
PLAY
+
CARD
(VCR)
,
+
CARD
CAMERA
PLAY
+
CARD
(VCR)
23
E