Yamaha Venture Lite PZ50RTB Owner's Manual page 35

1. Compression damping force adjusting knob
Compression damping setting:
Minimum (soft):
12 click(s) in direction (b)*
Standard:
7 click(s) in direction (b)*
Maximum (hard):
2 click(s) in direction (b)*
* With the adjusting knob fully turned in
direction (a)
Rebound damping force
The rebound damping force of each shock
absorber can be adjusted by turning its re-
bound damping force adjusting knob.
To increase the rebound damping force, turn
the adjusting knob in direction (a). To de-
crease the rebound damping force, turn the
adjusting knob in direction (b).
1. Rebound damping force adjusting knob
Control functions
Rebound damping setting:
Minimum (soft):
20 click(s) in direction (b)*
Standard:
12 click(s) in direction (b)*
Maximum (hard):
3 click(s) in direction (b)*
* With the adjusting knob fully turned in
direction (a)
TIP
The damping forces will not decrease past the
minimum levels even if the adjusting knobs
are turned out more than the minimum set-
tings.
ESU10937
Adjusting the spring preload of the
center shock absorber and the rear
torsion springs
The spring preload can be adjusted by turning
the adjusting ring (PZ50GT / PZ50MT /
PZ50VT) or adjusting nut (PZ50RT) on the
center shock absorber and the adjusters on
the rear torsion springs. Adjust the spring pre-
load as follows.
Center shock
PZ50MT / PZ50VT)
To increase the spring preload and thereby
harden the suspension, turn the adjusting ring
in direction (a). To decrease the spring pre-
load and thereby soften the suspension, turn
the adjusting ring in direction (b).
absorber (PZ50GT /
29