First steps
Display in idle status
Once the phone is registered and the time set, the idle
display is shown, as in this example. After successful reg-
istration, the following is displayed:
u
The strength of the signal between the base station
and handset:
– poor to good: Ò Ñ i Ð
– no reception: | flashes
u
Battery charge status:
outside the charger
– U white: charged over 66 %
– V white: charged between 33 % and 66 %
– e white or red
– = flashes red: battery almost empty (less than 10 minutes talktime)
in the charger
=
–
*
red: older firmware version, please update the handset's firmware
Please note
In idle status, the calendar display can be switched on and off (
Setting up area codes
Before you can return a call from the Calls list (
area code of the area in which your phone is being used. If your phone is in a mul-
tiple area code area, you must also store the extra codes for that area.
Local Area Code
Ï
¢
v
~
§Save§
a
Extra Codes
Ï
¢
v
~
§Save§
a
Repeat the above steps until all the extra codes have been entered for your area. A
maximum of five (5) extra codes can be stored.
Your phone is now ready for use!
14
*
: charged under 33 %
e
V
¢
¢
Telephony
Local Area Code
Enter the local area code.
Press the Display key.
Press and hold (idle status).
¢
¢
Telephony
Extra Codes
Enter the extra code.
Press the Display key.
Press and hold (idle status).
U white: battery is charging
¢
page 31), you must store the local
i
V
INT 1
14, 2009
Feb
07:15am
Calls
Calendar
¢
page 51)
(
¢
page 34).