Replacing Remote Control Batteries; Programming Replacement Remote Controls - Code Alarm Elite CA6155e Owner's Manual

Replacing Remote Control Batteries

4 Button Remote Control - Model CAT4ME
The batteries inside each remote control should last approximately 1 year under normal
use. When the batteries become weak you will notice the remote control range (the
distance from the vehicle the remote control will work) deteriorate and the small LED on
the remote control will dim. To replace the remote control batteries:
1. Remove 1 screw then disassemble the halves of the remote
control by unsnapping the back of the case.
2. Remove the old battery, observing the +/- symbols on the
batteries and replace with a new battery.
3. Reassemble the halves of the remote control and reinstall 1 screw.
4. Test operation of the remote control.
Programming Replacment Remote Controls
Remote Transmitter Programming
1. Turn the ignition ON.
2. Press and hold the valet/override button located on the antenna.
3. Within 10 seconds the system will chirp (3) three times.
4. Press 1 button of each transmitter you wish to program.
5. The system will respond with 1 chirp for each accepted transmitter.
6. Turn the ignition OFF to exit programming.
NOTES:
• The system will exit transmitter programming after 15 seconds of inactivity.
• This system has 1 button programming which simultaneously programs all channels
of the system.
• The system will hold up to 4 transmitters in memory, programming a 5th transmitter
will erase the oldest transmitter in memory.
• Pressing the valet/override button at anytime during transmitter programming will
advance to the feature bank programming.
2020 Voxx Electronics Corporation. All rights reserved. 15