Table of Contents
Advertisement
Adjusting Blade Guard Parallel With
Table
1.
Use foot pedal to lower and hold blade guard
in lowest position.
2.
Insert largest feeler gauge that will fit between
hold-down finger and table on right end of
blade guard (see Figure 41).
Hold-Down Finger
Figure 41. Using feeler gauge to check blade
guard clearance.
3.
Repeat Step 2 on left end of blade guard.
— If both hold-down fingers are same dis-
tance from table, no adjustment is required.
— If hold-down fingers are not same distance
from table, proceed to Step 4.
4.
Loosen blade guard hex bolt on side of blade
guard that needs adjustment (see Figure 42).
Figure 42. Location of blade guard hex bolts.
5.
Adjust blade guard until entire length is same
distance from table, then tighten hex bolt.
Model T32957 (Mfd. Since 09/21)
Feeler Gauge
Squaring
Front Scales
For the front scales to work properly, these scales
must be square to the blades.
Tools Needed
Machinist's Square ............................................ 1
Wrench or Socket 13mm ................................... 1
To square front scales:
1.
Use foot pedal to lower and hold blade guard
in lowest position.
2.
Place machinist's square against blade guard
and front scale.
— If scale is square to blade guard, no
adjustment is necessary.
— If scale is not square to blade guard, pro-
ceed to Step 3.
3.
Loosen (2) hex bolts for front scale that
needs adjustment (see Figure 39).
Figure 43. Location of front scale hex bolts.
4.
Place one side of machinist's square against
blade guard and adjust front scale against
other side of square.
5.
Tighten hex bolts from Step 3 to secure
position.
Qty
x 2
-29-
Advertisement
Table of Contents
