Table of Contents
Advertisement
7.
Insert (2) rear work stop support rods in holes
shown in Figure 14.
8.
Secure rear work stop supprt rods in place
by tightening pre-installed hex bolts (see
Figure 14).
Note: Rear work stop support rods should
extend same distance from back of machine.
If one rod extends farther than the other,
adjust hex bolts and rods until even.
Hex Bolt
Rear Work Stop
Support Rod
(1 of 2)
Figure 14. Rear work stop support rods installed
on machine.
9.
Install (2) rear work stop assemblies on rear
work stop support rods and tighten each
micro-adjustment knob completely to elimi-
nate space shown in Figure 15.
Rear Work Stop
Assembly
Figure 15. Rear work stop assembly installed on
rear work stop support rod.
-16-
Micro-Adjustment
Knob (1 of 2)
Eliminate
This Space
10. Align each work stop indicator to the same
number on rod scales, then tighten micro-
adjustment lock knobs and rear work stop
lock knobs (see Figure 16).
Work Stop
Indicator
Micro-Adjustment
Lock Knob
Figure 16. Rear work stop assembly
components.
11. Attach rear work stop to rear work stop assem-
blies with (2) M10-1.5 x 20 hex bolts and
10mm flat washers, as shown in Figure 17.
Rear Work
Stop Assembly
(1 of 2)
x 2
Figure 17. Rear work stop attached to rear work
stop assembly.
Model T32957 (Mfd. Since 09/21)
Rear Work Stop
Lock Knob
Rear
Work
Stop
Advertisement
Table of Contents
