Grizzly T32957 Owner's Manual page 25

Shearing Blades
Oil Type ................ SB1365 or ISO 68 Equivalent
Oil Amount ....................................... 1 or 2 Drops
Lubrication Frequency ..............................Weekly
Items Needed
Protective Gloves..........................................1 Pr.
Shop Rags ......................................... As Needed
Mineral Spirits .................................... As Needed
SB1365 or ISO 68 Equivalent ............ As Needed
While wearing protective gloves, use a rag and
mineral spirits to clean away grease and built-up
grime from the surfaces of the shearing blades
(Figure 31). Once the blades are dry, apply oil to
the surfaces with a clean rag.
Surface of
Shearing Blade
Figure 31. Location of lower shearing blade
surface.
Gibs & Slides
Oil Type ................ SB1365 or ISO 68 Equivalent
Oil Amount ....................................... 1 or 2 Drops
Lubrication Frequency ..............................Weekly
Items Needed
SB1365 or ISO 68 Equivalent ............ As Needed
Apply a few drops of oil at each gib (see Figure
32) weekly to keep the upper blade and hold-
down/blade guard moving smoothly.
Model T32957 (Mfd. Since 09/21)
Qty
Figure 32. Gib and slide lubrication point.
Rear Work Stop Assemblies
Oil Type ................ SB1365 or ISO 68 Equivalent
Oil Amount ....................................... 1 or 2 Drops
Lubrication Frequency ....................... As Needed
Items Needed
Shop Rags ......................................... As Needed
Mineral Spirits .................................... As Needed
SB1365 or ISO 68 Equivalent ............ As Needed
The rear work stop assemblies must slide smooth-
ly in order to achieve accurate measurements
when shearing. Clean the rear work stop support
rods with mineral spirits when you have any trou-
ble adjusting the rear work stop position. Apply a
few drops of oil to the locations shown in Figure
33 on each assembly.
Qty
Figure 33. Rear work stop assembly lubrication
locations.
Qty
-23-