Table of Contents
Advertisement
Hardware Setup
Installation
The baby-AT size of the AP41 system board easily fits most housings.
It has mounting holes that conform to the standard system housing.
Some housings may differ slightly in design, requiring additional steps
to install the board. Read the documentation that comes with the
housing.
Make sure that you have already installed
the system board components like the
CPU and memory, and have set the
appropriate jumpers before you proceed.
Installing the System Board
1.
Open the system housing.
2.
Use at least two screws that come with the housing to secure the
board.
3.
Attach the power supply cables to the power connector and the
front panel connectors to the multifunction connector. See the
section Connectors.
4.
Install any additional components that you have not yet installed.
2-28
User's Guide
Advertisement
Table of Contents
