JVC NX-F55 Instructions Manual page 57

5
Release [STB/VCR
NOTE
• It is recommended that you slide the remote
control mode selector to [AUDIO] after using this
function. Most of the other functions can be used
when the remote control mode selector is at
[AUDIO].
• Manufacturer codes are subject to change
without notice. You may not be able to operate
the VCR produced by the manufacturer.
• After replacing the batteries of the remote
control, set the manufacturer code again.
].
F
For the locations of the remote
control buttons, refer to page 49.
Using the remote control for the
VCR operation
Before the VCR operation, select the remote
control mode for the VCR.
■ IMPORTANT
• Slide the remote control mode
selector to the lowest position.
1
Press [VCR].
2
Operate the remote control by
pointing it at the VCR.
Remote control button Usage
[STB/VCR ]
F
[CH +/ ]
–
Number buttons
(1-10, 0, 10)
(playback)
3
7
8
y
1
[REC] + (playback)
3
[REC] +
8
NOTE
• When the remote control mode selector is slid to
the lowest position and [VCR] is pressed, some
buttons may not work.
• It is recommended that you slide the remote
control mode selector to [AUDIO] after using this
function. Most of the other functions can be used
when the remote control mode selector is at
[AUDIO].
Turns on/off the VCR.
Changes channels.
Selects the channels.
Starts playback.
Stops playback.
Pauses playback.
Fast-forwards the tape.
Fast-rewinds the tape.
Starts recording.
Pauses recording.
52