NETGEAR DG834Gv3 Setup Manual page 7

Table 1. LED Descriptions (continued)
Solid green
Blinking green
3. Wireless
Off
Solid green
Blinking green
4. USB
Off
Solid green
Blinking green
5. DSL
Off
Solid green
Blinking green
6. Internet
Red
Off
Getting to Know Your Wireless Router
The Wireless Access Point is enabled.
Data is being transmitted or received over the wireless link.
The Wireless Access Point is disabled.
A USB device is connected to the port.
Data is being transmitted or received over the USB port.
No USB device is connected to the port.
The ADSL port is synchronized with your ISP's DSL Access
Multiplexer (DSLAM).
The ADSL is synchronizing with the DSLAM. The LED blinks at a rate
of 2 Hz when the wireless ADSL2+ modem router is trying to detect a
carrier signal, and blinks at 4 Hz when the carrier has been detected
and the wireless ADSL2+ modem router is trying to train.
No link is detected on the ADSL port, or the wireless ADSL2+ modem
router is powered off.
The wireless ADSL2+ modem router is connected to the Internet. The
LED will remain solid green if the Internet session is dropped due to
an idle time-out, but an ADSL connection is still present. If the
session is dropped for any other reason, the LED will turn off.
The wireless ADSL2+ modem router is connected to the Internet and
traffic is passing through the device.
The wireless ADSL2+ modem router attempted to connect to the
Internet but failed.
The wireless ADSL2+ modem router is powered off, or in bridged
mode, or there is no ADSL connection.
3