Assembly - Pro-Form CrossWalk 325 User Manual

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a nor-
mal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply
wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrenches
rubber mallet
pliers .
To identify small parts during assembly, use the PART IDENTIFICATION CHART in the center of this manual.
1. Make sure that
the power cord
is unplugged.
With the help of a second person, carefully tip the
treadmill onto one side. Partially fold the Frame (84) so
that the treadmill will be more stable. Do not fully fold
the treadmill until it is completely assembled.
Attach four Base Pads (33) to the Base (38) with four
3/4" Tek Screws (89).
2. With the help of a second person, tip the treadmill down
to the position shown.
Attach a Wheel (42) to each side of the Base (38) with a
Wheel Bolt (41) and a Wheel Nut (22) as shown.
Refer to the inset drawing. Clip two U-nuts (10) over the
two round holes in each of the Uprights (14, 15) as
shown.
Identify the Right Upright (15) and the Left Upright (14)
(there are two small holes in the side of the Left
Upright). While a second person holds the Right Upright
near the Wire Harness (53), insert the end of the Wire
Harness into the lower end of the Right Upright and out
of the indicated hole near the upper end as shown. If
there are plastic ties in the lower ends of the Uprights,
remove the plastic ties.
, wire cutters
!
and your own phillips screwdriver
, adjustable wrench
1
84
38
2
5
, and needlenose
89
33
33
89
14
Holes
38
22
42
41
10
14, 15
,
33
89
15
53