Lexus GS450h Owner's Manual page 144

144
3-2. Opening, closing and locking the doors and trunk
Switching the door unlock function (vehicles with entry function)
■
It is possible to set which doors the entry function unlocks using the wireless remote con-
trol.
Turn the power switch off.
1
Cancel the intrusion sensor and tilt sensor of the alarm system to prevent unintended
2
triggering of the alarm during the setting change. (if equipped) (P. 94)
When the indicator light on the key surface is not on, press and hold
3
for approximately 5 seconds while pressing and holding
The setting changes each time an operation is performed, as shown below. (When
changing the setting continuously, release the buttons, wait for at least 5 seconds, and
repeat step
Multi-information
display
(Left-hand drive
vehicles)
(Right-hand drive
vehicles)
For vehicles with alarm: To prevent unintended triggering of the alarm, unlock the doors
using the wireless remote control and open and close a door once after the settings have
been changed. (If a door is not opened within 30 seconds after
doors will be locked again and the alarm will automatically be set.)
In case that the alarm is triggered, immediately stop the alarm. (P. 92)
GS450h_300h_OM_OM30F92E_(EE)
.)
3
Unlocking function
Holding the driver's door handle
unlocks only the driver's door.
Holding a passenger's door han-
dle unlocks all the doors.
Holding a door handle unlocks
all the doors.
or
.
Beep
Exterior: Beeps 3 times
Interior: Pings once
Exterior: Beeps twice
Interior: Pings once
is pressed, the