G-force display
■
The G-force values may not be zero even when the vehicle is parked, such as when it is
●
parked on an incline.
Depending on the vehicle usage conditions, the brake fluid pressure display may not
●
reach its maximum reading even though the brake pedal is fully depressed.
If a 12-volt battery terminal is disconnected and reconnected, the steering amount dis-
●
play may be disabled temporarily. After driving the vehicle for a while, the display will
be enabled.
Depending on the condition of the vehicle, the brake fluid pressure display may change
●
even when the brake pedal is not depressed.
System check display
■
After turning the power switch to ON mode, opening image is displayed while system
operation is checked. When the system check is complete, the normal screen will return.
Suspension of the settings display
■
In the following situations, the settings display using the meter control switches will be
suspended.
When a warning message appears on the multi-information display
●
When the vehicle begins to move
●
Tire inflation pressure (if equipped)
■
It may take a few minutes to display the tire inflation pressure after the power switch is
●
turned to ON mode. It may also take a few minutes to display the tire inflation pressure
after inflation pressure has been adjusted.
"---" may be displayed if the tire information cannot be determined due to unfavorable
●
radio wave conditions.
Tire inflation pressure changes with temperature. The displayed values may also be dif-
●
ferent from the values measured using a tire pressure gauge.
When disconnecting and reconnecting 12-volt battery terminals
■
The drive information will be reset.
Liquid crystal display
■
P. 109
GS450h_300h_OM_OM30F92E_(EE)
2. Instrument cluster
117
2