Service Manual
SEC.1-7
Disassembling covers (7)
A
6. Lay the machine on its back for easier removal
of covers. Remove front cover. Remove CPU
board and FFC-28 from front cover with care.
*FFC is flexible flat cable
B
B
5. Insert small screw driver into clearance
between front and rear covers and then lift up the
front cover to remove two covers as shown at left.
* Once hooked portions A, B and C as shown
above are removed, other mating portions may be
removed easily.
Original issue
May 2014
Page 9/64
Model
XL-420
| 9
C
C