Advertisement
Service Manual
SEC.13-2
Adjustment of timing of take-up lever to
shuttle (2)
Adjustment
1. Remove front cover.
2. Loosen two hex screws on main shaft gear (A) which is engaged with take-up operating
gear (B).
3. While inserting screw driver into accessible hex screw, turn main shaft in either way to
get correct timing of take-up lever to shuttle.
4. Tighten 2 screws securely after adjustment.
Note: Gear A is fixed by collar C and B. If collar B is adjusted, make sure gear A must be
tightened securely.
A
Original issue
Page 35／64
Model
C
A
B
May 2014
XL-420
| 35
B
Advertisement
