Blower/Fan Installation; Fan Operation; Fan Wiring; Operating Instructions - Regency Alterra CS1203 Owners & Installation Manual

Freestanding wood stove

Hide thumbs

Table Of Contents

Table of Contents

INSTALLATION

BLOWER/FAN INSTALLATION

1) Remove the five screws from the back panel of the unit - to remove the

fan cover plate.

2) Slide the fan up into the rear heat shield.

3) After aligning holes, secure the fan to the rear heat shield using the five

screws removed earlier.

4) Secure the bottom of the fan using the two fan clips (in manual package)

and two bottom screws removed in step 1.

Note: The connection cord should not be in contact with any hot

surfaces.

Read the operating instructions for the fan before using.

5) Plug fan into a properly grounded three prong receptacle.

Automatic

To operate the fan automatically, push the bottom switch on the side of the fan housing to "AUTO" and the top switch to either "HIGH" or "LOW" for fan speed.

This will allow the fan to turn on as the stove has come up to operating temperature. It will also shut the fan system off after the fire has gone out and the

unit cooled to below a useful heat output range.

Manual

To manually operate the fan system push the bottom switch to "MAN" and the top switch to either "HIGH" or "LOW". This will bypass the sensing device and

allow full control of the fan.

Switching from "AUTO" to "MAN" or "HIGH" to "LOW" may be done anytime.

WARNING: Electrical Grounding Instructions

This appliance is equipped with a three pronged

(grounding) plug for your protection against shock

hazard and should be plugged directly into a properly

grounded three-prong receptacle. Do not cut or remove

the grounding prong from this plug.

Remove back panel