Operation - Ryobi CDC18022 User Manual

GB
FR DE ES
FEATURES
MODEL BATTERY PACK
(not included)
BPP-1815
BPP-1815M
BPP-1817
BPP-1817M
BPL-1820
CDC1802 BPL-1815
BPP-1815
BPP-1815M
BPP-1817
BPP-1817M

OPERATION

WARNING:
Do not allow familiarity with products to make
you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses
with side shields when operating products.
Failure to do so could result in objects being
thrown into your eyes, resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories
not recommended by the manufacturer of this
product. The use of attachments or accessories
not recommended can result in serious personal
injury.
TO INSTALL BATTERY PACK(not included)
See Figure 2.
Q Place the rotation selector in center position.
Q Align raised rib on battery pack with groove in drill's
battery port.
Q Make sure the latches on each side of the battery
packsnap in place and that battery pack is secure
before beginning operation.
TO REMOVE BATTERY PACK(not included)
Q Place the rotation selector in center position.
Q Locate latches on side of battery pack and depress
both sides to release battery pack from the drill.
Remove battery pack from the drill.
IT NL PT DK SE
CHARGER
(not included)
BCL-1800
BCL1418
BCS618
BC-1815S
BC-1800
FI NO RU PL CZ
English
BATTERY PROTECTION FEATURES
Ryobi 18 V lithium-ion batteries are designed with
features that protect the lithium-ion cells and maximize
battery life. Under some operating conditions, these
built-in features may cause the battery and the tool it is
powering to act differently from nickel-cadmium batteries.
During some applications, the battery electronics may
signal the battery to shut down, and cause the tool to
stop running. To reset the battery and tool, release the
trigger and resume normal operation.
NOTE: To prevent further shut down of the battery, avoid
forcing the tool.
If releasing the trigger does not reset the battery and
tool, the battery pack is depleted. If depleted, the battery
pack will begin charging when placed on the lithium-ion
charger.
WARNING:
Battery products are always in operating
condition. Therefore, the switch should always
be locked when not in use or when carried at
your side.
SWITCH TRIGGER
To turn the drill ON, depress the switch trigger. To turn it
OFF, release the switch trigger.
VARIABLE SPEED
The switch trigger delivers higher speed and torque
with increased trigger pressure and lower speed with
decreased trigger pressure.
NOTE: You might hear a whistling or ringing noise from
the switch during use. Do not be concerned; this is a
normal part of the switch function.
ROTATION SELECTOR (FORWARD/REVERSE/
CENTER LOCK)
See Figure 3.
The direction of bit rotation is reversible and is controlled
by a selector located above the switch trigger. With
the drill held in normal operating position, the rotation
selector should be positioned to the left of the switch
trigger for drilling. The drilling direction is reversed when
the selector is to the right of the switch trigger.
Setting the rotation selector in the OFF (center lock)
position helps reduce the possibility of accidental starting
when not in use.
CAUTION:
To prevent gear damage, always allow the chuck
to come to a complete stop before changing the
direction of rotation.
2
HU RO LV LT EE
(See Figure 3.)
HR SI SK GR TR