Features; Assembly; Operation - Ryobi R87701 Operator's Manual

FEATURES

PRODUCT SPECIFICATIONS
Chuck ...........................................................3/8 in. Keyless
Switch ..........................................................Variable Speed

ASSEMBLY

WARNING:
Do not use this product if it is not completely as-
sembled or if any parts appear to be missing or
damaged. Use of a product that is not properly and
completely assembled or with damaged or missing
parts could result in serious personal injury.
If any parts are damaged or missing, please call 1-800-539-1710 for assistance.

OPERATION

WARNING:
Do not allow familiarity with this product to make
you careless. Remember that a careless fraction of
a second is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this tool.
The use of attachments or accessories not recom-
mended can result in serious personal injury.
APPLICATIONS
You may use this tool for the following purposes:
 Drilling in all types of wood products (lumber, plywood,
paneling, composition board, and hard board)
 Drilling in ceramics, plastics, fiberglass, and laminates
 Drilling in metals
No Load Speed .......................... 0-500/0-1900/min. (RPM)
Torque ................................................................... 375 in.lb.
WARNING:
Do not attempt to modify this product or create ac-
cessories or attachments not recommended for use
with this product. Any such alteration or modifica-
tion is misuse and could result in a hazardous con-
dition leading to possible serious personal injury.
CAUTION:
This drill is not intended to be used for mixing
concrete, drywall, grout or other similar types of
viscous mixtures. Failure to obey this caution could
cause poor performance, possible injury, and will
void your warranty.
WARNING:
Battery tools are always in operating condition.
Therefore, switch should always be locked when
not in use or carrying at your side.
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 10.
 Lock the switch trigger.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured in the
product before beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
6 – English