Skoda Superb 2005 Owner's Manual page 79

78 Seats and Stowage
Adjusting the height of a head restraint
– Grasp the side of the head restraint with both hands and push
it up or down in direction of arrow
protection is achieved if the top edge of the head restraint is at
the same level as the upper part of your head
fig. 133.
Adjusting the angle of a head restraint
– The head restraint can be matched to the head of the occu-
pant by adjusting the angle in the direction of the arrow
Adjusting the angle of the head restraint provides enhanced
comfort for the user.
Removing and installing a head restraint
– Pull the head restraint out of the backrest of the seat as far as
the stop.
– Press the locking button in the direction of arrow
fig. 58 and pull the head restraint out.
– To re-insert the head restraint, push it down into the backrest
of the seat far enough until you hear the locking button
engage.
The head restraints of the front seats can be adjusted for angle and height
⇒ page 77, fig.
57, the outer head restraints at the rear can be adjusted
for height (about 15 mm). The middle rear head restraint is fixed.
The head restraints must be adjusted to match the size of the seat occu-
pant. Correctly adjusted head restraints together with the seat belts offer
effective protection for the occupants ⇒ page 151.
A ⇒ page 77, fig.
57. Best
A
⇒ page 151,
A
.
B
⇒ page 77,
WARNING
•
The head restraints must be correctly adjusted in order to offer
effective protection for the occupants in the event of an accident.
•
Do not drive under any circumstance with removed head
restraints - risk of injury!