Table of Contents
Advertisement
56
Unlocking and locking
– Position the flat blade of a screwdriver (car tool kit) carefully
against the rear edge of the cover of the power roof drive
⇒ page 55, fig.
33.
– Pull the cover down.
– Take the crank handle out of the inside of the cover.
– Press the crank handle
⇒ page 55, fig.
34.
– Hold the crank pressed and turn it - the roof closes.
– Insert the crank handle into the cover again.
– Press on the cover again by first of all inserting the plastic lugs
and then pushing the cover up.
– Have the fault rectified by a specialist workshop.
Note
It is necessary after each emergency operation (using crank handle) to
move the sliding/tilting roof into the basic position. Here you have to set
the control dial to the switch position
forward for about 10 seconds.
A
fully into the hexagon hole
1
A
⇒ page 53, fig. 32
and press it
A
A
2
Advertisement
Table of Contents
