Skoda Superb 2005 Owner's Manual page 112

Note
•
The whole heat output will be needed to unfrost the windscreen and
side windows. No warm air will be fed to the footwell. This can lead to
restriction of the heating comfort.
•
If the cooling system has not been switched on for a lengthy period,
odours may be produced at the evaporator because of deposits. Switch
the air conditioning system on at least once a month for approximately 5
minutes at the highest blower stage - also during the cold season of the
year - in order to remove such odours. Also open a window for a short
time.
•
Please refer to the information regarding recirculated air mode
⇒ page 112.
Setting air conditioning system
Recommended settings of air conditioning controls:
Defrosting the windscreen and side windows
•
A
Turn control dial
A
•
A
in position 4,*
Blower switch
B
•
Turn the air distribution control
•
Close the air outlet vents 3,*
•
Open air outlet vents 4
side window.
Keeping windscreen and side windows demisted
We recommend that you use the following setting in cases where the
windows are misted up more than usual (e.g. when it is raining):
•
A
Blower switch in position 2,*
B
Using the system Safety
⇒ page 110, fig. 107
to the right up to the stop,*
A 
into the position ,*
C
⇒ page 113, fig. 108
and point towards the
Driving Tips
Heating and air conditioning system
•
Turn the air distribution control
 ,*
•
Close the air outlet vents 3,*
•
Open air outlet vents 4 and point towards the side window,*
•
Switch on the cooling system by pressing button
Warming up the inside of the vehicle as rapidly as possible
•
A
Turn control dial to the right up to the stop,*
A
•
A
Blower switch in position 3 or 4,*
B
•
Turn the air distribution control
•
Open the air outlet vents 3 and 4,*
•
We recommend pressing button
windows can steam up in this position however.
Heating the vehicle to a comfortable temperature
We recommend the following setting once the windows are no longer
misted up and the desired temperature has been reached:
•
A
Control dial at the desired heat output,*
A
•
A
Blower switch in position 1 or 2,*
B
•
Turn the air distribution control
•
Close the air outlet vents 3,*
•
Open the air outlet vents 4,*
•
Set the air distribution regulator
windscreen gets misted up again, as required.
Cooling down the inside of the vehicle as rapidly as possible
•
close all windows and the sliding/tilting roof,*
•
A
Turn the control dial to the left up to the stop,*
A
•
A
Blower switch in position 4,*
B
•
Turn the air distribution control
•
Open the air outlet vents 3 and 4,*
General Maintenance Breakdown assistance
A
into the position between  and
C
A
.
E
A

into the position ,*
C
A
air recirculation mode. The
D
A
into the position  ,*
C
A
between positions  and  , if the
C
A
into the position  ,
C
Technical Data
111