Extension Wings - RIDGID R4560 Operator's Manual

EXTENSION WINGS

Hardware Bag "C,D"
1.
Attach the Extension Wings to the Table using three 5/16-18 x
7/8 Hex Screw with Split Lock Washers
The Wings attach from underneath as shown in Figure 9. Be
sure to use a Level or Ruler to keep the Extension Wings level
with the Table. NOTE: Hole patterns on the two long edges of
the extensions are different. See Figure 9A.
2.
Attach the Extension Wings to the Front and Rear rails using
four 5/16-18 x 1-1/8 inch Flat Countersunk Hex Screw
5/16-18 inch Hex Flange Nuts
Front and Rear Rails are level with the Extension Wings by
using the Rail Alignment Gauge
3.
Repeat this process on Front and Rear Rails for both Left and
Right Extension Wings.
4.
Attach the Spreader Bar
and Rear Rails using four M8 x 16 Hex Shoulder Screws
and M8 Nylock Nuts . See Figure 11.
HP9
ASSEMBLY
for each Wing.
HP7
. Be sure to confirm the
HP15
.
HP20
to the outboard end of the Front
PC17
and
HP13
HP8
14
HP7
UNDERSIDE OF WING UNDERSIDE OF WING
Figure 9
RIGHT EXTENSION RIGHT EXTENSION
WING WING
PC10
HP13
Figure 10
HP9
PC17
HP8
Figure 11
Figure 9A
HP15