Front And Rear Rails - RIDGID R4560 Operator's Manual

FRONT AND REAR RAILS

Hardware Bag "D"
1.
Attach the Front Fence Rails
using four 5/16-18 x 1-1/8 inch Flat Countersunk Hex
Screw , and 5/16-18 inch Hex Flange Nuts
HP15
shown in Figure 4 and 5.
NOTE: The Front Rails have holes on both surfaces of the rail for
attachment to both the Table and the Fence Guide.
2.
Attach the Rail Union Plate
Countersunk Hex Shoulder Screw
Nuts in the two holes where the Rail Sections meet. As
HP10
seen in Figure 5.
3.
Use supplied Rail Alignment Gauge
Rails are the proper distance from the top of the Table. See
Figure 6.
4.
Attach the Rear Fence Rails
5/16-18 x 1-1/8 inch Flat Countersunk Hex Screw
5/16-18 inch Hex Flange Nuts
supplied Gauge to ensure the Rail is the proper distance
from the top of the Table. See Figures 7 and 8.
ASSEMBLY
(1&2) to the Table Front
PC19
, as
HP13
using two M5 x16mm Flat
HP12
and M5 Nylock
HP11
to ensure the
HP20
to the Table with four
PC18
and
HP15
. Use the slot in the
HP13
FRONT LEFT RAIL FRONT LEFT RAIL
PC19
HP11
HP12
HP10
HP15
PC18
REAR LEFT RAIL
13
HP13
(SHORT) (SHORT)
1
Figure 4
FRONT RIGHT
RAIL (LONG)
2
PC19
Figure 5
Figure 6
REAR RIGHT RAIL
PC18
Figure 7
HP15
Figure 8
HP15