Wiring Example For The Factory Settings - Siemens SINAMICS G110M Getting Started

Commissioning

4.2 Wiring example for the factory settings

Table 4- 1
Component or tool
Operator Panel
Optical cable
STARTER
StartDrive
PC Connection Kit Contains the 3 m USB cable necessary to
SD card
Internet: STARTER download
1)
(http://support.automation.siemens.com/WW/view/en/26233208)
Internet:StartDrive download
2)
(http://support.automation.siemens.com/WW/view/en/68034568)
4.2 Wiring example for the factory settings
To ensure that the factory setting of the interfaces can be used, you must wire your drive as
shown in the following examples.
Factory pre-assignment of the interfaces on the drive
For a complete technical specification of the individual connections, please refer to following
section of this manual:
Figure 4-2
66
Components and tools for commissioning and data backup
IOP-2 Handheld Kit
Required for using IOP Handheld Kit with
CU240M
Commissioning tool (PC software) - Version
1)
4.3.3 or later
Commissioning tool (PC software) - Version
2)
12 or later
connect your converter to a PC.
Optional memory card for storing and trans-
ferring the converter settings
Connection and cables (Page 53)
Macro 29 - Conveyer with potentiometer and fixed setpoint (Default USS)
Article number
6SL3255-0AA00-4HA1
3RK1922-2BP00
DVD: 6SL3072-0AA00-0AG0
DVD: 6SL3072-4CA02-1XG0
6SL3255-0AA00-2CA0
6SL3054-4AG00-2AA0
Distributed converter for SIMOGEAR geared motors
Getting Started, 04/2018, FW V4.7 SP10, A5E36100338B AG