Dell E36S Series Owner's Manual page 96

c. heat sink and processor
d. iDRAC port card, if installed
Steps
1. Disconnect all cables from the system board.
CAUTION: Take care not to damage the system identification button while removing the system board from the
chassis.
2. Remove the screws on the system board, and slide the system board toward the front of the chassis.
3. Hold the system board by the touch points and lift it out of the chassis.
CAUTION: To prevent damage to the system board, do not lift the system board by holding a memory module,
processor, or other components; hold the system board by its edges only.
Figure 56. Removing the system board
a. touch point (2)
b. system board
c. system board t-handle post
96 Installing and removing system components