Rack Mounting; Rack-Mounted Installation Requirement - ZyXEL Communications GS1900 Series User Manual

Note: Make sure the screws are fastened well enough to hold the weight of the Switch with
the connection cables.
Align the holes on the back of the Switch with the screws on the wall. Hang the Switch on the screws.
4
Note: Make sure there is enough clearance between the wall and the Switch to allow
ventilation.
The Switch should be wall-mounted horizontally. The Switch's side
panels with ventilation slots should not be facing up or down as this
position is less safe.

2.5 Rack Mounting

The Switch can be mounted on an EIA standard size, 19-inch rack or in a wiring closet with other
equipment. Follow the steps below to mount your Switch on a standard EIA rack using a rack-mounting
kit.
Note: Make sure there is enough clearance between each equipment on the rack for air
circulation.

2.5.1 Rack-mounted Installation Requirement

The following are the rack-mounted installation requirements:
• Two mounting brackets.
• Eight M3 flat head screws and a #2 Philips screwdriver.
• Four M5 flat head screws and a #2 Philips screwdriver.
Failure to use the proper screws may damage the unit.
GS1900 Series User's Guide
26