Figure 253 Maintenance > Firmware > Management
The following table describes the labels shown under Images Information.
Table 187 Maintenance > Firmware > Management
LABEL
Image Select
Active Image
Apply
Cancel
Images Information
Flash Partition
Image Size
Created Time
33.2.2 Select the Active Image
The available partition is shown under Image Select.
Follow the steps below to choose the active image, which will be the default partition during boot.
When you selected the active image and saved the changes, the other one will be the backup.
If you are facing problems with the active partition when booting, the Switch will use the backup one
and it'll be loaded automatically.
1.
In Active Image, choose the backup image according to the information displayed in Images Infor-
mation.
2.
Click Apply to activate the backup image.
OR
Click Cancel to discard the changes.
Chapter 33 Maintenance
DESCRIPTION
Select which firmware should load, click Apply and reboot the Switch to see changes.
Click Apply to save the changes.
Click Cancel to discard the changes.
Displays the partition number.
Displays the size of the partition image in bytes.
Displays the date and time when the image was created in the Coordinated Universal Time
(UTC) format.
GS1900 Series User's Guide
239